HTP SuperStor Ultra Indirect Fired Water Heaters - Manual (Page 5)

5
LP-83 Rev. 3.24.14
PRODUCTS TO AVOID AREAS LIKELY TO HAVE CONTAMINANTS
Spray cans containing fluorocarbons Dry cleaning/laundry areas and establishments
Permanent wave solutions Swimming pools
Chlorinated waxes/cleaners Metal fabrication plants
Chlorine-based swimming pool chemicals Beauty shops
Calcium chloride used for thawing Refrigeration repair shops
Sodium chloride used for water softening Photo processing plants
Refrigerant leaks Auto body shops
Paint or varnish removers Plastic manufacturing plants
Hydrochloric or Muriatic acid Furniture refinishing areas and establishments
Cements and glues New building construction
Antistatic fabric softeners used in clothes dryers Remodeling areas
Chlorine-type bleaches, laundry detergents, and cleaning solvents Garages and workshops
Adhesives used to fasten building products
Table 1 – Chemical Contaminants
F. WATER TEMPERATURE ADJUSTMENT
If the water heater is going to have a set temperature above 120 o F, you must use an
ASSE 1017 rated mixing valve to avoid severe burns or death from scalding
temperature.
Households with small children, disabled, or elderly persons may require a
120
o F or lower temperature setting to prevent severe personal injury or death
due to scalding.
PART 2 – PREPARE THE WATER HEATER
UNCRATING HEATER – Any claims for damage or shortage in shipment must be filed immediately against the transportation company
by the consignee.
COLD WEATHER HANDLING – If the heater has been stored in a very cold location (BELOW 0 o
F) before installation, handle with care
until the plastic components come to room temperature.
Remove all sides of the shipping crate to allow the heater to be moved into its installation location.
APPROXIMATE TIME / TEMPERATURE RELATIONSHIPS IN SCALDS
120
o
F More than 5 minutes
125 o F 1 ½ to 2 minutes
130 o F About 30 seconds
135 o F About 10 seconds
140 o F Less than 5 seconds
145
o
F Less than 3 seconds
150
o
F About 1 ½ seconds
155
o
F About 1 second
Table 2