Janam XT85 - Manual (Page 48)

Data Capture—Barcode Scanning XT85 User Manual
Janam Technologies LLC 6 ―6
Scanning Demonstration
Note:
The ScanWedge function must be enabled for the Scan Demo function to operate.
The ScanWedge function will be disabled if manual scanning is initiated either by a
command API or by using the Janam Barcode Test Program.
To configure ScanWedge and enable
Symbologies:
1. From the Windows Mobile Start
screen scroll down and tap Utilities
(folder) > ScanWedge (icon).
2. Set preferences with individual pull-
down menus for ScanWedge, Beep
Sound and Light Mode.
3. Enter Prefix to send before
barcode and Suffix to send after
barcode or leave blank.
4. Check or clear box options.
5. Tap Menu > Setup >
Symbology Config.
6. Tap Enable All to enable all barcode
types or manually select the
barcode type(s) to enable.
7. Tap OK to save.
8. Tap
Menu (Taskbar) > Setup >
Hardware Test to confirm that all
scanner functions are working
properly.
9. Select (check) each Hardware Test
item individually to verify proper
functioning.
10. Tap OK.
11. Tap Apply to enable ScanWedge.