Avenview SW-HDM3D-C5-8X8 - Manual (Page 15)

www.avenview.com 15
1.10.2 Display Side
1.10.2.1Method A: Push Button
Press the INPUT SELECT push button to switch the input source on the respective output port connected to
the matrix receiver in sequential order. The selected input source will be displayed on the LED of INPUT
CHANNEL.
1.10.2.2Method B: IR Remote Control for Switching Input Channels
Please decide which input channel to be selected by pressing Source Selection 1 to Source Selection 8. Or
you can use left and right button to enter IR control mode and select the input channel in
ascending and descending order respectively. The setting will be effective in a couple of seconds.
Switch input port in descending order*
Switch input port in ascending order*
SOURCE SEL. 1
Switch the display channel at the remote
site to input port 1
SOURCE SEL. 2
Switch the display channel at the remote
site to input port 2
SOURCE SEL. 3
Switch the display channel at the remote
site to input port 3
SOURCE SEL. 4
Switch the display channel at the remote
site to input port 4
SOURCE SEL. 5
Switch the display channel at the remote
site to input port 5
SOURCE SEL. 6
Switch the display channel at the remote
site to input port 6
SOURCE SEL. 7
Switch the display channel at the remote
site to input port 7
SOURCE SEL. 8
Switch the display channel at the remote
site to input port 8
Right ( ) button to switch input source in ascending order (1, 2, 3, 4, 5, 6, 7, 8, 1, 2, ......)
Left ( ) button to switch input source in descending order (1, 8, 7, 6, 5, 4, 3, 2, 1, 2, ......)