Avenview SW-HDM3D-C5-8X8 - Manual (Page 22)

www.avenview.com 22
2.2 Method 2: Use the Front Panel of The Master Unit
Button Function
Output Port
EDID will be read from display via the connected receiver unit from the
respective output port
Input Channel
The EDID will be sent to the input source connected to respective HDMI input
port
One by One learning
1. Select the desired Output Port and Input Channel that you want the EDID of the display connected to this
specified output port can be learned for the specified input channel.
2. Press the “+” button of the Output Port and “−” button of the Input Channel” at the same time for 2
seconds.
3. Release these two buttons. The EDID will be read from the receiver unit connected to the display and sent
the Output Port then written to the chosen Input Channel.
4. If the operation is successful, the Input Channel will show “O” (OK). If the operation is not successful, it will
show “F” (failure).
One to All learning
1. Press the “” button of the Output Port and the “” button of the Input Channel” at the same time for 2
seconds.
2. Release these two buttons. . The EDID will be read from the receiver unit connected to the display and sent
the Output Port then written to all eight Input Channels.
3. If the operation is successful, the Input Channels will show “O” (OK). If the operation is not successful, it
will show “F” (failure).