Avenview SW-HDM3D-C5-8X8 - Manual (Page 9)

www.avenview.com 9
1.7.3 Dip Switch for EDID & Audio Settings (SW1 – SW8)
DIP Switch Position
Video Audio Description PIN # 1 PIN # 2
OFF  OFF  1080p Surround
Default Mode
1
: EDID up to 1080p & Surround sound
Audio Output up to 7.1Ch
(DTS-HD Master & Dolby TrueHD)
OFF  ON  720p/1080i Stereo
2
Safe Mode
2
: Forces system to output at 720p/1080i
with Stereo Audio.
ON  OFF  Bypass Bypass
EDID Learning Mode
3
: for learning EDID from the
display while playing any received HDMI Audio format.
ON  ON  Bypass
4
Stereo
4
EDID Learning & Stereo Mode
5
: For learning EDID from
the display while enforcing stereo output.
1. Factory default setting of [SW1]-[SW8] is pin-1 at OFF [] & pin-2 at OFF [] for 1080p video and surround
sound audio.
2 If the HDTV shows video but without audio, please try to set audio mode to stereo.
3 If you encounter any unsolved audio/video output problem during system installation, please turn any
[SW1]-[SW8] to pin-1 at ON [] & pin-2 at OFF [] for safe mode to select the system EDID up to 720p(1080i) video
and stereo audio for system check. However, the safe mode cannot be initiated if your HDMI source is set to enforce
1080p output. In this case, please reconfigure your HDMI source to all resolution output for troubleshooting.
4 Bypass means the matrix will maintain playing the original format of HDMI signals in video and perhaps audio.
By setting at this mode, the users may encounter compatibility issue among different kinds of HDMI sources and
displays. If you cannot get the audio and/or video output normally at the system installation, please change the DIP
switch setting to default mode or even safe mode to verify the functionality of the device.