ADC Modem MM701G User Manual
Page 52
Setting Up the WAN
46
MM701G User Manual
2
Select a session by typing the session number at the
Select session for editing prompt
to
display the
WAN Session Options
screen.
3
Type
10
to select the VPI parameter, then enter the values supplied by your service
provider.
4
Type
11
to select the VCI parameters, then enter the values supplied by your service
provider.
5
If you are operating in Router mode, you also need to enter the WAN ADSL Port ID
address and the associated WAN IP subnet mask. Both of these values are provided by your
service provider.
6
Select
Apply
to activate your changes.
Apply
immediately activates the changes that you have
made for this session.
7
Select
Save New System configuration
from the Main Menu as described in
Current Configuration” on page 60
or the changes will be lost upon reboot or power cycle.
Session Parameters
1. Session Name
Bridge
10. VPI
0
2. WAN Protocol
RFC1483 Bridge
11. VCI
35
3. State
Enabled
12. QOS
UBR
4. IP Addressing
N/A
13. QOS Peak Cell Rate
5. IP Address
N/A
14. Encapsulation
LLC
6. IP Net Mask
N/A
15. Login Name
N/A
7. NAT
N/A
16. Login Password
N/A
8. RIP Send
N/A
17. Authentication
N/A
9. RIP Accept
N/A
18. Apply
Select parameter to edit (Return to exit) ->