Setting up dhcp – ADC Modem MM701G User Manual
Page 55
Chapter 4: Managing the Modem Using the Console Port & Telnet
MM701G User Manual
49
Valid values for the parameters shown on the LAN Setup screen are defined in the following
table.
Setting Up DHCP
This procedure is optional. Follow this procedure to enable or disable DHCP on the modem.
From the Main Menu, select
LAN Setup
screen and enter values for the following DHCP
parameters:
1
To enable DHCP, select
DHCP
and choose either
Client
or
Server
by typing
2
or
3
on the LAN
Setup menu. If
DHCP Client
is selected, you do not need to configure an IP address.
None
disables DHCP.
2
Enter the low range of the DHCP IP addresses as supplied by your LAN administrator.
3
Enter the high range of the DHCP IP addresses as supplied by your LAN administrator.
4
Enter the default gateway address that is provided to the requesting DHCP client—only if
you are operating in server mode. This IP Address is also available from your LAN
administrator.
5
Enter the DNS address that is provided to the requesting DHCP client—only if you are
operating in server mode. This IP Address is also available from your LAN administrator.
LAN Parameter
Valid parameter Values
LAN Protocol
Router or Bridge.
IP address
IP address assigned by your LAN administrator, or DHCP
server (Default 10.0.0.1).
IP Net Mask
IP address assigned by your LAN administrator, or DHCP
server (Default 255.255.255.0).
Default Gateway
Default Gateway provided by your access provider.
DHCP
Client, Server, or None.
DHCP Range Low Address
DHCP low range IP address supplied by your LAN
administrator.
DHCP Range High Address
DHCP high range IP address supplied by your LAN
administrator.
DHCP Gateway Address
In DHCP Server Mode, this is the gateway address that is
automatically assigned to the requesting DHCP client.
DHCP DNS
In DHCP Server Mode, this is the DNS address that is
automatically assigned to the requesting DHCP client.
Apply
Apply Settings.