LEDGlow Million Color SMD LED Underbody Lighting Kit with Bluetooth Connectivity User Manual
Page 4
Android Device Pairing Instructions (Android 2.3 & Up Required).
Step 1
Make sure your Million Color Underbody Control Box w/ Bluetooth Connectivity is powered and the LED status indicator is solid yellow. This will indicate
that your control box is now ready to be paired to your Android device. If the LED status indicator is red, hold the power button
for four seconds while
the LED is still red and the lights are off, and release when the LED turns yellow to enter pairing mode.
Step 2
On your Android device, navigate to your
“Bluetooth Settings,” which is found in your
“Settings” app, and make sure Bluetooth is
currently enabled. Once you enable your
Bluetooth connection you will see the screen
below or one that looks very similar to it.
Step 3
Select the “LEDGlow-SEEBlue” device to begin
pairing to the control box. You can ignore the pin
code number and just select “Pair”. If the
“LEDGlow-SEEBlue” controller is not appearing
under the “Bluetooth devices” tab, select “Search
for devices” so your Android device will scan for
nearby Bluetooth accessories. If after this step
your device is still not finding the controller, (1)
Make sure the controller has 12V of power, (2)
Restart your Android device and try again.
Step 4
Once your Android device is paired correctly, the
status on your screen will change from “Available
Devices” to “Paired” or “Paired but not
connected”. The control box’s LED status
indicator will change to solid green once it has
been successfully paired and ready to connect.
Step 5
Before you can begin using the Bluetooth Enabled Control Box, you must download and install the LEDGlow Mobile Control App from the Google Play
Store. The app can be found by searching with the keyword, “LEDGlow.”