LEDGlow Million Color SMD LED Underbody Lighting Kit with Bluetooth Connectivity - Manual (Page 6)

Part 6 – For Both Android and iOS
When the LEDGlow Mobile Control App loads, the main screen and
functions will be grayed out until you touch the power button that is
located in the upper left hand corner.
Part 7 – For Both Android and iOS
Once power is applied to your Million Color Underbody Kit and you have hit
the power button in the top left corner of the app, physically check the
underbody or interior lights to see if they are illuminated.
Device Pairing Tips & Troubleshooting

Disconnect from the control box when you are not using it. This can simply be done by either turning off Bluetooth in the Settings app or by
getting out of range of the control box. Exiting the LEDGlow Mobile Control App will not disconnect your iOS device from the controller as the
app was designed for multitasking with other apps, such as answering a phone call, or surfing the web and then switching back to the Mobile
Control App, all while keeping your connection active. The same can be done in the Android version
by either turning off Bluetooth in the
Settings app, getting out of range of the control box or shutting down the app by double tapping on your device’s “Back” button while inside the
app.

This control box was designed with a power save mode to be enabled after 8 hours of inactivity with your device. This allows the control box to
draw minimum power, ensuring it does not drain your vehicle’s battery. It may take an additional minute when attempting to reconnect back to
the controller while it is currently in power save mode, if you are using iOS. To prevent any battery drain when not in use, you can install the
control box to a 12V switched source to completely remove power at your choosing.
 If you have Bluetooth switched “On” in your Settings app and the controller is powered, your iOS device will attempt to connect to the controller
whenever it is in range. You do not need to pair and manually connect to the controller after the initial setup if you are using the same device.
Your Android device will connect once your device pairs to your control box and you open the app.
 In the event that your Android/iOS device cannot connect to the controller, you may try one of the following:
o Restart/Power Cycle your Android/iOS device
o Restart your Bluetooth enabled control box by disconnecting power to it for 20 seconds
o If all else fails, while the lights on the kit are turned off, hold the power button on the controller for four seconds while the LED status
indicator is solid red and release once the LED turns solid yellow. The controller will now be in pairing mode. Next, go into your
Bluetooth settings in the Settings app and tap the arrow on the right side of the “LEDGlow-SEEBlue” device, and then select “Forget this
Device.” Finally, restart your Android/iOS device and continue on from Step 2 in the above pages to do a fresh pairing with the control
box.

The control box operates independently from the app. In the event that your Android/iOS device is not available for use, the control box provides
full lighting functionality with color, mode and speed buttons, designed to fully operate the lighting kit without the LEDGlow Mobile Control App.
You cannot save any presets from the control box; therefore, once you open the app back up, the current lighting configuration shown on your
device’s screen will be immediately synchronized back to the controller.

You can have only one device paired to your control box at a time. Any attempt to try and connect to the control box with a different device
while the control box is not currently in pairing mode will be rejected and an error message will appear.