LEDGlow Million Color SMD LED Underbody Lighting Kit with Bluetooth Connectivity User Manual
Page 5
Apple Device Pairing Instructions (iOS 5.0 & Up Required):
Step 1
Make sure your Million Color Underbody Control Box w/ Bluetooth Connectivity is powered and the LED status indicator is solid yellow. This will indicate
that your control box is now ready to be paired to your Apple device. If the LED status indicator is red, hold the power button
for four seconds while
the LED is still red and the lights are off, and release when the LED turns yellow to enter pairing mode.
Step 2
On your Apple device, navigate to your
“Bluetooth Settings,” which is found in your
“Settings” app, and make sure Bluetooth is
currently enabled. Once you enable your
Bluetooth connection you will see the screen
below or one that looks very similar to it.
Step 3
Select the “LEDGlow-SEEBlue” device to begin
pairing. Ignore the pin code number shown and
just select “Pair.” Should an error message
appear when attempting to pair, be sure the LED
status is solid yellow and try again. If you
continue to receive error messages, restart your
iOS device.
Step 4
Once your iOS device is paired to the controller,
the status on your screen will change from “Not
Paired” to “Connected”. The control box’s LED
status will change to solid green once it is
“Connected” and ready for use.
Step 5
Before you can begin using the Bluetooth Enabled Control Box, you must download and install the LEDGlow Mobile Control App from iTunes or by clicking
App Store when the app prompts you to download. The app can be found by searching with the keyword, “LEDGlow.”