LevelOne WCS-6050 - Manual (Page 27)

Network Camera User’s Manual
27/54
Network
Any changes made on this page will restart the system in order to validate the
changes. Make sure every field is entered correctly before clicking on “Finish”
Network Setting
LAN / PPPoE / WIRELESS LAN
The default setting is LAN. Select PPPoE if using ADSL dialup.
1. LAN
The default status is Get IP address automatically. This could be tedious to
perform software installation whenever the Network Camera starts. Therefore,
once the network is set, the IP address should be entered correctly. Select Use
fixed IP address then the Network Camera will skip installation. The Network
Camera will automatically restart and operate normally after a power outage. You
can run CamFinder to check the IP address assigned to the Network Camera if
the IP address is forgotten, or you can use the UPnP function provided by the
Network Camera.