LevelOne WCS-6050 - Manual (Page 29)

Network Camera User’s Manual
29/54
to connect to the wireless device with the highest transmitting rate.
(2) Security: Select the data encryption method
- None: Do not use data encryption.
- WEP: Allows communication only with other devices which are with
identical WEP settings.
- WPA-PSK: Use WPA pre-shared key.
- WPA2-PSK: Use WPA2 pre-shared key.
(3) Auth Mode: Choosing one of the following modes, (Default setting is
OPEN).
- Open: communicates the key across the network.
- Shared: allows communication only with other devices with identical
WEP settings.
(4) Key length: The administrator can select the key length of 64 or 128 bits.
64 bits is the default setting.
(5) Key format: Choose one of the following formats. HEX is the default
setting.
- HEX digits consist of the numbers 0~9 and the letters A-F.
- ASCII is a code for representing English letters as numbers from
0-127 except “, <, > and space characters that are reserved.
(6) Network Key: Enter a key in either hexadecimal or ASCII format. When
selecting different key length, acceptable input length is listed as following:
64 bits key length: 10 Hex digits or 5 characters.
128 bites key length: 26 Hex digits or 13 characters.
Note: When 22(“), 3C(<) or 3E(>) are input in network key, the key format
can’t be changed to ASCII format.
(7) Algorithm: Choose one of the following algorithms for WPA-PSK modes:
- TKIP
- AES
(8) Pre-shared Key” Enter a key in ASCII format. The length of the key is 8
~ 63
2. Ad-Hoc: Make the Network Camera connect directly to a host equipped
with a wireless adapter in a peer-to-peer environment.
(1) Channel: Under infrastructure mode, the channel will be selected
automatically to match the channel setting for the selected Access Point.
Under Ad-Hoc mode, the channel must be manually set to the same channel
for each wireless adapter. The default channel setting depends on the
installed region.
(2) TX rate: This field is for selecting the maximum transmission rate on the
network. The default setting is “auto”. It means the Network Camera will try
to connect to the other wireless device with highest transmitting rate.
(3) Security: Select the data encrypt method
- None: Do not use data encryption.
- WEP: allows communication only with other devices with identical
WEP settings.
(4) Auth Mode: Choose one of the following modes (Open is the default