LevelOne WAP-6101 - Manual (Page 12)

Configuration
(Slave to Slave)
(Press 3 sec) the easy configuration process also supports
“Slave to Slave” configuration.
1. Press the WEC/Reset button of the first Slave
AP (say Slave1 that has been paired and
configured) for 1~3 seconds, release it to trigger
the WEC process. Then, the WiFi LED flashes
fast.
2. Press the WEC/Reset button of the second
Slave AP (say Slave2 that is an un-configured
Slave AP) for 1~3 seconds, release it to trigger
the WEC process. Then, the WiFi LED flashes
fast.
3. After a few seconds (normally about 30~60
seconds). The Slave1 and Slave2 APs can be
paired automatically, and auto-duplicates the
wireless setting of the Slave1 as that of the
Slave2.
(If there is something wrong during paring the
two devices, the process will be finished in 2
minutes.)
Once the easy configuration process completed,
the Status LED will be recovered to its original
behavior (prior to you triggered it).
AP Mode
Toggling
WEC/Reset
(Press 8 sec)
There are two alternative AP modes defined for the
device to operate with WEC (Wireless Easy
Connection) feature. One is Master Mode (by
default), and the other is Slave Mode.
To change the AP mode from one to the other, you
have to:
1. Press the WEC/Reset button for 6~10 seconds,
and then release it.
2. The WiFi LED becomes OFF in 3 ~ 5 seconds,
3. After about 20 ~ 25 seconds, the WiFi LED will
be lit ON again to indicate that the AP Mode is
changed.
It takes about 36 seconds to change (toggle) the
AP Mode completely.
WiFi Green LED : Device is in Master Mode
WiFi Amber LED: Device is in Slave Mode
Reset Slave AP WEC/Reset 1. Press the WEC/Reset button for about 11~15