LevelOne WAP-6101 - Manual (Page 40)

5. VLAN ID: This device supports mapping of a SSID to a certain VLAN ID to
separate the workgroups across wireless and wired domains. By default, it is not
enables. If you enabled this function, you have to specify a VLAN ID for the
wireless network.
6. Max Supported Stations: You can specify the number of maximum stations that
can associate to the SSID simultaneously.
7. Channel: The radio channel number. The permissible channels depend on the
Regulatory Domain. The factory default setting is auto channel selection. It’s
recommended to choose a channel that is not used in your environment to reduce
radio interference
8. Bandwidth: The default setting for Bandwidth is “Auto”. You can change it to
“20MHz” with care if some clients are suffering from the connectivity problem in
higher bandwidth setting.
9. Authentication & Encryption: You may select one of the following
authentications to secure your wireless network: Open, Shared, Auto, WPA-PSK,
and WPA2-PSK.
Afterwards,
click on “Save” to store your settings or click “Undo” to give up the
changes.
3.1.2.2 Advanced Wireless Setup
This device provides advanced wireless setup for professional user to optimize the
wireless performance under the specific installation environment.
3.1.2.2.1 Advanced RF Module1 Settings