System Sensor FAAST Networking User Manual
Page 10
Advertising
User Guide: FAAST Fire Alarm Aspiration Sensing Technology® Networking
5. Examine the existing settings for your connection. If you use this adapter to connect to other networks, you should write
down the settings so you can restore them later.
6. Configure the network adapter to use a static IP address as shown below.
Note:
The IP address you choose for the PC must be different than the IP address of the detector.
7. Choose OK to save the settings. Then click OK to save and close the Local Area Connection properties.
8. Network adapter configuration is complete. Test connectivity by pinging the detector. See Testing Connectivity for
instructions.
Note:
Some PCs may require a restart for the settings to take effect.
10
Advertising