System Sensor FAAST Networking User Manual

Page 12

Advertising
background image

User Guide: FAAST Fire Alarm Aspiration Sensing Technology® Networking

12

4. Examine the results. By default, the ping program attempts to contact the detector four times. If at least one reply is received, the

PC is able to contact the detector.

Configuration

The first step in deploying a networked FAAST detector is determining the IP address it should use and the method by which the ad-

dress will be assigned. IP addresses can either be assigned statically and programmed into the device or assigned dynamically by

a special server using the DHCP protocol. The FAAST detector supports either method of address assignment. If you are unsure of

the method and address to use, contact your network administrator for assistance.

The PipeIQ software is required to change the network configuration of the FAAST detector. Instructions for IP configuration are shown

below.

1. Start the PipeIQ software application.
2. If you have previously created a project, open it using File -> Open. Otherwise, create a new project using File -> New.
3. Double-click FAAST Device1 from the navigation pane to open the Configuration window.

Advertising