System Sensor FAAST Networking User Manual
Page 20
Advertising
User Guide: FAAST Fire Alarm Aspiration Sensing Technology® Networking
20
Editing and Saving
Once a configuration has been created or retrieved, the software can be used to edit the configuration parameters of the detector.
Parameters are divided into three categories: General, Relays and Thresholds, and Network. When all the detector parameters have
been set, the configuration can be saved to the project file using the File -> Save command.
Changing Detector Configuration
When the configuration has been edited to the desired state, it can then be sent to the detec-
tor using the Send Configuration command.
The PipeIQ software will confirm the configuration change with the following message and the detector will shut down and restart.
Advertising