Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 82)

Teledyne LeCroy Recording Rules Overview
70 Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual
2. Drag the selected events from the Available Events area into either the Global State
Cell or the Sequence Cell (see “Recording Rules Overview” on page 68 ).
Global State Cell
If you want the Analyzer to always search for the event, place it in the cell marked
Global State.
Sequence Cell
To create an event sequence, place two or more events in the faintly marked cell
that reads Drag an event here to add a new sequence. At this point, the selected
events have no effect because an action has not been assigned.
3. To select a sub‐set of your selected event, right‐click it and choose Properties. A
Properties dialog opens that presents additional options. For example, if you open
the Properties dialog for Errors, you can set the specific types of errors the Analyzer
should look for.
4. Assign an action to the selected events by right‐clicking each of the events, selecting
Specify Action from the pop‐up menu, and assigning an action such as Trigger,
Filter, or Count. Be sure to click the event itself and not the State cell that it is sitting
in (which produces a different pop‐up menu).
Figure 5.17: Assigning an Action
Note:
You can also assign actions to events by double‐clicking the event or action and selecting the
Actions page when the Properties dialog opens (see “Event Properties Dialog Box Features” on
page 83 ).
Click OK to close the dialog. At this point, assuming that the other options in the
Recording Options dialog have been set (such as the General page), you can begin the
recording by pressing the Start Recording button.