Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual User Manual
Page 84
Advertising
Teledyne LeCroy
Resources
72
Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual
To set a TS1 Packet Match Resource, click on the New Event button and select Ordered
Set: TS1. The Ordered Set: TS1 displays in the Available Events panel. Double‐click on the
TS1 to select the specific fields and go to the Layout tab to change the pre‐defined bits.
Figure 5.19: Setting Up a Packet Match Resource - TS1
Defining Gen3 Layout tab does not mean the that analyzer will trigger on a TS that
happens just at Gen3. Gen3 Layout will allow you to define the bits but if these bits are
matched at any other speed the analyzer will trigger.
Advertising