Teledyne LeCroy USB Analyzer Automation Manual - Manual (Page 139)

Teledyne LeCroy Automation API Reference Manual for USBTracer, USB Advisor, and Voyager USB Protocol
Suite
139
Set the Host Name or IP Address of the Host Controller
You must identify the device upon which the client will execute its commands.
Note: If you are writing a C/C++ program for automation, you can skip the following steps because you
will specify the remote machines programmatically.
1. With the Properties dialog box still open, click the Location tab.
The Location window displays.
2. Select the option Run application on the following computer.
3. In the text box below the selected option, enter the Host Name or IP address of the Host Controller.
If you do not know the name of the Host Controller, you can browse to it using the
Browse ... button.
4. Click OK.
The Properties dialog box closes. You see the Distributed COM Configuration Properties
dialog box.