Teledyne LeCroy USB Analyzer Automation Manual - Manual (Page 137)

Teledyne LeCroy Automation API Reference Manual for USBTracer, USB Advisor, and Voyager USB Protocol
Suite
137
A.4. DCOM Client Configuration
DCOM client configuration is a four-step process:
1. Set authentication to occur upon connection with the Host Controller.
2. Set the Host name or IP address of the server to which the client will connect.
3. Set commands to run on the Host Controller.
4. Set the network protocol over which DCOM will run.
Setting When and How Authentication Should Occur
You specify when and how the client should be authenticated by performing the following steps:
1. Click the Windows Start button.
2. Select Run ...
The Run dialog appears.
3. In the Open edit box within the Run dialog, type dcomcnfg.
4. Click OK.
The following dialog box appears:
This dialog box presents a list of applications on the PC that support DCOM.
5. Select USBTracer/Trainer, USB Advisor, or Voyager (USB Protocol Suite) from the list of
applications.