Teledyne LeCroy USB Analyzer Automation Manual - Manual (Page 143)

Teledyne LeCroy Automation API Reference Manual for USBTracer, USB Advisor, and Voyager USB Protocol
Suite
143
2. Double-click AnalyzerClient.exe.
The application starts. If you prefer, you can copy the executable to your hard drive and
launch it from there.
3. Enter the IP address or Host Name of the Host Controller.
4. Press Connect.
The status message at the bottom of the window should change from Ready to a message that reads
something like USBTracer: Version 1.70. This change indicates that a connection has been established
to the Host Controller.
When you have completed this step, the Interface software automatically launches on the Host
Controller.
If the message "The RPC server is unavailable" appears, check the network connections between the
two PCs. Also try using the IP address in place of the Host Name (assuming that you had originally used
the Host Name).
If the message "Access denied" appears, make sure that the account that you are using on the Host
Controller is the same as the one you are using on the client PC and that both have Administrator
privileges.
5. Click the button next to the Trace File text box. You are going to browse for a trace file. If you are
going to run the commands over a network, you must supply the network path.
6. Browse for a trace file of your choice. If you do not have a trace file on your PC, you can select one
from an Installation diskette. When you have selected a file, its name should appear in the Trace File
text box.
7. Press the button marked Open File. A message should appear at the bottom of the window listing the
trace name, file size (in packets) and trigger position.