Teledyne LeCroy PCIBX64-X - Manual (Page 8)

6
JUMPERS, PCIBX
SW
Installed => Mechanical switch may be used to control the extender, so long as software control has not
been used. (Default)
Not Installed => Mechanical switch is disabled
JP15
Installed => PCIBX board ID is PCI_1 (Default)
Not Installed => PCIBX board ID is PCI_2
JP3
Installed => UUT I/O signals = System VIO
Not installed => Allows UUT and systems of different VIO voltages (5V and 3.3V)
to operate together (Default)
JP4
Installed => -12V source is from the system.
Not Installed => -12V source is from the external input.
JP5
Installed => +5V source is from the system.
Not Installed => +5V source is from the external input.
JP6
Installed => +12V source is from the system.
Not Installed => +12V source is from the external input.
JP7 Installed 1-2 => +3.3V to UUT is from On-board source.
Installed 2-3 => +3.3V to UUT is from system.
Not installed => +3.3V to UUT should be from the external source.
JP10
Installed => UUT VIO is connected to the system VIO.
Not Installed (Default) => UUT VIO not connected to the system VIO, but connected to the UUT
power plane.
JP16 For factory use only.
JP17
Installed between 1 and 2 => PCI-X enable signal driven by the UUT.
Installed between 2 and 3 => PCI-X enable signal set to 66 MHz.
Not installed => PCI-X enable signal is not supported (Default)
J4
Factory use.