Teledyne LeCroy PCIBX64-X - Manual (Page 9)

7
SPECIFICATION: PCIBX32-5, PCIBX32-3, PCIBX64-5, PCIBX64-3
Bus: PCIBX32-5, PCIBX64-5 == 32/64-bit PCI, Top connector = 5V key
PCIBX32-3, PCIBX64-3 == 32/64-bit PCI, Top connector = 3.3V key
Voltages:
Input requirement +5V at 200 mA, +/- 12V at 50 mA , +3V at 50 mA .
Inputs From PC bus or the external input, configurable by jumpers per voltage.
Output Ratings +5V @ 5 Amp , higher than 5 Amp current limit can be accommodated
per user request.
+3.3V @ 2.5 Amps if on-board regulator is used.
+3.3V @ 5 Amps if system provides 3.3 Volts.
+VIO @ 1 Amp.
+/- 12V @ 1 Amp.
Drop Across the Switches 40 millivolts drop for every 1 Amp drawn for +5V, +3.3V and +VIO.
30 millivolts drop for every 1 Amp drawn for -12V.
30 millivolts drop for every 100 milliampere drawn for +12V.
Propagation Delay: Less than 500 Pico-seconds from the PC bus to the UUT. The switch
propagation delay is rated at only 250 Pico-seconds.
On-Off Controls: SPST switch on-board, or the system parallel port.
Outputs:
J3 +5V, +12V and +3.3V current draw by the UUT can be measured at a
four-point terminal, J3, by a voltmeter. Each volt represents 1 Amp.
JP1 JP1-1 to JP1-59, all odd pins on the B side, 100 mil centers.
JP1 JP1-2 to JP1-60, all even pins on the B side, 100 mil centers.
JP2 JP2-1 to JP2-59, all odd pins on the A side, 100 mil centers.
JP2 JP2-2 to JP2-60, all even pins on the A side, 100 mil centers.
JP13, JP14 Extended Signal for 64 bit as marked (PCIBX64 only).
The signals at JP1, JP2, JP13 and JP14 are active when the extender power is on and tri-stated when the power is off.
Mechanical Dimensions:
Height 4.5 inches
Length 7.2 inches