Teledyne LeCroy QPHY-USB3-Tx-Rx - Manual (Page 9)

QPHY-USB3-Tx-Rx Software Option
917719 Rev A
9
Oscilloscope Option Key Installation
An option key must be purchased to enable the QP HY-USB3 option. Call LeCroy Customer Support to place an
order and receive the code.
Enter the key and enable the purchased option as follows:
1. From the oscilloscope menu select Utilities  Utilities Setup...
2. Select the Options tab and click the Add Key button.
3. Enter the Key Code using the on-screen keyboard.
4. Restart the oscilloscope to activate the option after installation.
Typical (Recommended) Configuration
QualiP HY software can be exec uted from the oscilloscope or a host computer. The first step is to install QualiPHY.
Please refer to the Qu
aliPHY Operator’s Manual for installation instructions.
LeCroy recommends running QualiP HY on an oscilloscope equipped with Dual Monitor Display capability (Option
DMD-1 for oscilloscopes where this is not standard). This allows the waveform and meas uremen ts to be shown
on the oscilloscope LCD display while the QualiPHY application and test results are displayed on a second
monitor.
By default, the oscilloscope appears as a local host when QualiPHY is executed in the oscilloscope. Follow the
steps under Oscilloscope Selection (as follows) and check that the IP address is 127.0.0.1.
Remote (Network) Configuration
It is also possible to install and run QualiP HY on a host computer, controlling the oscilloscope with a Netwo rk/LAN
Connection.
The oscilloscope must already be configured, and an IP address (fixed or network -assigned) must already be
established.
Oscilloscope Selection
Set up the oscilloscope using QualiPHY over a LAN (Local A rea Net work ) by doing the following :
1. Make sure the host computer is connected to the s ame LA N as the oscilloscope. If unsure, contact
your system administrator.
2. From the oscilloscope menu, select Utilities  Utilities Setup…
3. Select the Remote tab.
4. Verify the oscilloscope has an IP address and the cont rol is set to TCP/IP.
5. Run QualiP HY in the host computer and click the General Setup button.
6. Select the Connection tab.
7. Enter the IP address from step 4 (previous).
8. Click the Close button.
QualiP HY is now ready to control the oscilloscope.