Terk DTOC User Manual - Manual (Page 7)

6
Mounting the DTOC to a surface
D
TOC
Wood screw
Mounting base
2. Mount the base to the surface.
Find the four wood screws
included in this package. Using
these screws, attach the base to
the surface as shown here.
3. Attach the arm to the base.
Find one of the screws,
washers, and nuts included in
the package.
First, set the washer and nut
in the mounting well. Then
position the arm over the other
side of the well. Attach the arm
to the base as shown here.
4. Attach the antenna to the arm.
Find the other screw, washer,
and nut.
First, set the washer and nut in
the antenna's mounting well.
Then position the arm over the
other side of the well. Attach
the arm to the antenna as
shown here.
1. Orient the antenna base.
Note: For best performance,
mount this antenna horizontally.
Make sure the base is oriented
correctly for the direction you
want to point the antenna. Use
the illustration on the left as a
guide.
Mounting
Well
Antenna points this way
...
...or this way
.
continues on next page...