Vanguard VCBA S2 (DigiTMR S2, DigiTMR S2 PC, CT-6500 S2, CT-7000 S2, CT-7500 S2, CT-8000) - Manual (Page 68)

VCBA S2 VERSION 4.xx SOFTWARE MANUAL REV 3
65
5.5 Transferring a Test Plan to a Circuit Breaker Analyzer
To transfer a test plan from the PC to a connected circuit breaker analyzer:
1. Make sure the VCBA-S2 software is running. Connect the CB analyzer to the PC via either
the RS-232C or USB port.
2. The CB analyzer should enter Computer Interface Mode.
3. Click on the Upload to Device icon in the Test Plan command group in the Command
Ribbon.
4. The following window will be displayed:
The “Folder” section displays the location of the default test plan folder. If your test
plans are located in a different folder, click on the folder icon at the top right of the
window and navigate to the folder containing your test plans.
From the list of test plan files, click on the filename that you would like to transfer to the
connected CB analyzer. You can select multiple files by holding down the [CTRL] key and
clicking on each filename.
Click on the “OK” button.