Warner Electric Dairy Cap Chuck - Manual (Page 11)

Warner Electric • 800-825-9050 P-2021 11
Figure 37
Place unit into vice. Using FIX-0019 and 1 1/8”
or 28mm” socket wrench remove nut from top of
housing. See figure 34.
Remove the two set screws from housing of unit
using a 3mm hex wrench. See figure 35.
Move adjustable end plate until spring and pin are
visible. Remove pin and spring from housing. See
figure 36.
Pull magnet stack away from housing. Set magnet
stack aside. See figure 37.
Figure 34
Figure 35
Figure 36
Clutch Rebuild Procedure