Warner Electric Dairy Cap Chuck - Manual (Page 17)

Warner Electric • 800-825-9050 P-2021 17
Figure 61
Figure 58
Figure 59
Figure 60
Install spacer onto shaft. See figure 58.
Apply thin layer of grease to black driver magnet
inside housing. See figure 59.
Place magnet stack inside of housing. Line up the
hole on the adjustable end plate with one of the
set screw holes on the housing. Be careful as the
magnets will attract together and snap into place.
See figure 60.
Place small spring inside of the aligned holes. Then
place pin, flat side up, into the hole. See figure 61.