Part ii, Setting the target zone alarm – Acumen EON-2028HS User Manual
Page 48
Upper Limit (blinking)
- Press STR/LAP Button
B
or STP/RESET
Button
C
to adjust the value.
- Press MODE/NXT Button
D
to proceed to the
next item.
Lower Limit (blinking)
- Press STR/LAP Button
B
or STP/RESET
Button
C
to adjust the value.
- Press MODE/NXT Button
D
to exit and return
to the Heart Rate Mode.
Step 2
LAP
LAP
Step 3
Note:
Press SET Button
A
to toggle between the heart rate limit in BPM or
Percentage of your Maximum Heart Rate in the Setting Mode.
Setting the Target Zone Alarm
If you set the Target Zone Alarm to ON, the watch will beep when you are
above or below the selected Target Zone. From the Select TZ Mode, press
& hold STP/RESET Button
C
to set the Target Zone Alarm to ON or OFF.
ON is indicated by the " " icon.
From the Select TZ Mode, press MODE/NXT Button
D
four times to return
to the Analog Time Display.
44
Part II
B
D
C
B
D
C