Acumen EON-2028HS - Manual (Page 56)

- If you want to re-select the Heart Rate Training Zone or re-set the
Interval Timer before the next lap, stop the present lap by pressing
STP/RESET Button
C , then set the watch. When you return to the
Chrono Mode, (it shows the total exercise time) you can start the
stopwatch beginning with a new lap.
Record a Session
- When you finished an exercise session, stop the stopwatch, then press &
hold STP/RESET Button C in the Chrono Mode to store all recordings
into watch memory (at the same time the stopwatch is reset to zero).
That will enable you to review all exercise data in the Recall Data Mode.
Note:
The watch has 99 laps display. When it goes over 99 laps, it will start from
lap 1 again, and it will keep 1 session and the last 50 laps in memory.
Start the Interval Timer
If the interval timer is set to ON, it replaces the stopwatch in the Chrono
Mode. When the interval timer finishes the watch produces a long beep for
indication. See the below figure:
Part II
52
Record a Lap
- While the stopwatch is running, press STR/LAP Button B to record a
lap and start the new lap. The watch will freeze the display of the first lap
for 7 seconds before displaying the new lap.