Extron Electronics SW HDMI Series User Guide - Manual (Page 16)

SW HDMI Series • Installation 10
Enabling Auto-input Switching
You can set up the SW HDMI to automatically select the active, connected input based
on detection of an active video signal (TMDS clock activity). If two or more inputs
are active, the input with the highest number is selected (for example, input 4 on
an SW4 HDMI switcher). When auto-input switching is in effect, the green Auto Switch
LED on the front panel lights and the front panel input selection buttons are disabled.
To enable auto-input switching:
1. Cut a small piece of wire to use as a jumper.
2. Insert the ends of the wire into slots 4 and 5 of the provided 5-pole
captive screw plug, connecting pins 4 and 5 together.
3. Use a small screwdriver to tighten the two screws above pin slots 4 and 5
of the plug so that the jumper wire ends remain securely in place (see the
illustration at right).
4. Insert the plug into the 5-pole Auto-SW captive screw connector on the
rear panel.
Figure 9 shows an SW4 HDMI with a jumper connecting pins 4 and 5 to enable auto-input
switching.
0.3A
MA
X POWER
12V
1
Tx
Rx
RS-232
AUT
O
2
3
4
INPUTS
OUTPUT
REMOTE
Figure 9. Auto Pins of the Remote Connector with a Jumper Installed
Auto-input switching remains in effect as long as the jumper wire connects the two pins
and the 5-pole captive screw plug is attached to the Remote connector.