MoJack PRO - Manual (Page 2)

MoJack PRO Lift MoJack PRO Lift
2 3
Introduction
This manual contains assembly, parts, operating,
maintenance, adjustment and safety instructions
for your MoJack PRO lift.
BEFORE USING YOUR MOJACK PRO, CAREFULLY
READ THIS MANUAL IN ITS ENTIRETY.
By following these operating, maintenance and safety
instructions, you will prolong the life of your MoJack
lift and promote safe operation.
If additional information is needed, or should you
require a trained service mechanic, contact your
authorized MoJack equipment dealer or distributor.
All MoJack parts are thoroughly tested and inspected
before leaving the factory to ensure that they comply
with all relevant safety standards.
NOTE: Please save this manual for future reference.
Warnings and Safety Instructions
IMPORTANT: The MoJack PRO is intended for use with riding lawn mowers and riding lawn tractors only. Do not
exceed 750 lbs. It should never be used to service other types of machinery unless there is an approved MoJack
accessory fitted for the type of machinery. Please consult your local MoJack dealer or distributor.
Read and understand all safety and operating instructions before using the MoJack PRO.
Never allow anyone unfamiliar with the safety or operating instructions to use the MoJack PRO.
Follow all safety and servicing instructions provided by the lawn mower’s manufacturer before using
the MoJack PRO.
Do not modify the MoJack in any way. Any modifications will void any and all warranties and could
compromise your personal safety.
When using the MoJack PRO, keep ALL bystanders at a safe distance away from the MoJack PRO.
The MoJack PRO must be used on a solid level surface.
Do not lift the front end and the back end of the mower at the same time.
Do not use MoJack PRO lift for anything other than a mower, unless the proper accessory is used.
Always stop engine and remove key before beginning any work on the mower.
Never operate the mower’s engine while using the MoJack PRO.
Do not exceed the lifting capacity of 750 lbs.
If the MoJack PRO Tower is leaning while lifting or lowering the mower, this indicates an overload
condition. Remove the mower immediately.
Tower must be locked in place with the Tower Locking Pin before using the MoJack PRO.
Do not remove safety warnings or decals from MoJack PRO.
Before each use, always check for any worn, loose or damaged parts on the MoJack PRO. If any
damaged parts are present, do not use the MoJack PRO and contact MoJack at 1-877-575-3173.
Do not climb on mower while it is lifted, being lifted or being lowered.
No one should be on the mower while it is lifted, being lifted or being lowered.
After the mower is raised to a working height, always place wheel chocks (not included) behind the back
tires of the mower.
Wheel Pads must be equal distance from the Lift Arm to maintain proper balance.
Remove all mower attachments before using the MoJack PRO.
Failure to follow these warnings may result in property damage and serious bodily injury or death.
NOTE: Location of unit Serial Number.
MODEL MoJack PRO
SERIAL No.
MAX.LOAD 750 lbs / 340 kg
Manufacturer: MoJack
Address: 3535 N. Rock Road, Wichita KS 67226 USA
MOJACKPRO # # # #
Patent No. 7,823,861 and No. 7,789,375.
© 2011 MoJack Distributors, LLC.
MoJack and the MoJack logo are registered trademarks of MoJack Distributors, LLC.
MoJack PRO is a trademark of MoJack Distributors, LLC. All rights reserved.