MoJack PRO - Manual (Page 9)

MoJack PRO Lift MoJack PRO Lift
16 17
Clevis Pin
Hair Pin
Lift Arm
Push Pin
Lift Arm Insert
Lift Arm Insert
Push Pin
Operating Instructions
STEP 18
Removing LIft Arm Inserts
• Remove Lift Arm Push Pins and pull Lift Arm Inserts
from the Lift Arm.
• Store the Push Pins in the Lift Arm.
STEP 19
Unhooking the Lift Arm
• Remove Small Hair Pin and Clevis Pin from Lift Arm.
• Unhook the Lift Arm from the Carrier by lifting up on the
front of the Lift Arm and pulling out.
• Store the Clevis Pin and Hair Pin in the Lift Arm.
Lift Arm
Top Bar of Carrier
Slotted Area
Preparing the MoJack PRO for Storage (Steps 17 - 20)
STEP 17
Removing the Wheel Pads
• Remove Wheel Pad Push Pins and pull
Wheel Pads out from the Lift Arm Inserts.
• Store the Push Pins in the Wheel Pads.
Push Pin
Lift Arm Insert
Wheel Pad
Tower
Locking Pin
Operating Instructions
STEP 21
Raising the MoJack PRO with a power drill
(optional)
• The MoJack PRO can be raised or lowered by using a
variable speed corded drill (7 amp minimum) or variable
speed cordless drill (18V minimum).
• The drill will require a 7/16” socket (not provided).
• Remove the Winch Handle by removing the
Nylock Nut and Winch Handle Washer.
• Firmly place the 7/16” socket on the Drill Reducer.
Rotate the drill in reverse (counterclockwise) to raise
the Lift Arm and rotate the drill forward (clockwise) to
lower the Lift Arm.
• Ratchet Release Handle and Grip Handle must be
squeezed together when lowering the Lift Arm.
• Follow all other operating instructions while using the drill attachment.
• Replace the Winch Handle for future use.
Operator must have a firm grip on the drill before
raising or lowering the Lift Arm.
Drill Reducer
7/16” Socket
Remove Winch Handle
STEP 20
Folding the MoJack PRO
• Pull and rotate Tower Locking Pin 90 degrees to the unlocked position.
• Raise the Tower out of the Base by pulling up on the Grip Handle and
then lower the Tower.
• Secure the Tower by rotating Tower Locking Pin until ring drops into
locking slot.
THE MOJACK PRO IS NOW READY FOR STORAGE OR TRANSPORT.
Tower
Locking Pin