Powermate PWZ0142700.01 - Manual (Page 13)

Copyright © 2011 MAT Industries, LLC M100135 13 - ENG
4� Add RV antifreeze or windshield washer fluid to hose
as shown. (Fig. 14)
5� Pull engine starter rope slowly several times until
antifreeze/ washer fluid comes out of high-pressure
hose connection of pump�
6� Remove garden hose from water inlet of pump�
7� Reconnect spark plug wire.
STORAGE
• SAVE ALL INSTRUCTIONS
ENGINE
Consult the Engine Owners Manual for the manufacturer’s
recommendations for storage�
PUMP
The manufacturer recommends using a pump protector/
winterizer when storing the unit for more than 30 days and/
or when freezing temperatures are expected� If a pump
protector/winterizer is not available, RV antifreeze or wind-
shield washer fluid needs to be run through the pump as
outlined in the steps below�
NOTE: Using a pump protector/ winterizer, RV antifreeze
or windshield washer fluid is to provide proper lubrication
to the internal seals of the pump regardless of tempera-
ture or environment�
1� Obtain a funnel, 6 oz� of RV antifreeze or windshield
washer fluid, and 16–36” of garden hose with a male
hose connector attached to one end�
CAUTION
RISK OF PROPERTY DAMAGE. Use only
RV antifreeze. Any other an ti freeze is corrosive and
can damage pump.
2� Disconnect spark plug wire.
3� Connect length of garden hose to water inlet of pump.
REPAIRS
• SAVE ALL INSTRUCTIONS
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by an Autho-
rized Warranty Service Center� Always use identical replacement parts� For the location of the nearest Authorized War-
ranty Service Center call 1-888-895-4549 or visit our website www�powermate�com�
FIG. 14