Powermate PWZ0142700.01 - Manual (Page 7)

Copyright © 2011 MAT Industries, LLC M100135 7 - ENG
ASSEMBLY INSTRUCTIONS (CONT.)
• SAVE ALL INSTRUCTIONS
4� Slide handle onto bottom portion of frame assembly�
(Fig. 3)
5� Insert saddle bolts into appropriate hole location and
attach with knobs (both sides). Tighten securely. (Fig. 3)
6� Roll the unit off the carton and discard carton�
7� Connect high-pressure hose to pump outlet� Tighten
securely. (Fig. 4)
8. Connect wand to gun. Tighten securely. (Fig. 5)
9� Attach high-pressure hose to gun� Tighten securely�
(Fig. 6)
NOTE: The pump on this unit is maintenance free and
requires no oil, if there is a problem with the pump contact
an Authorized Service Center�
WARNING
RISK OF BURSTING. Use a tire pres-
sure gauge to check the tires pressure before each use
and while inflating tires; see the tire sidewall for the correct
tire pressure�
NOTE: Air tanks, compressors and similar equipment
used to inflate tires can fill small tires similar to these very
rapidly� Adjust pressure regulator on air supply to no more
than the rating of the tire pressure� Add air in small incre-
ments and frequently use the tire gauge to prevent over
inflation.
FIG. 4
FIG. 5
FIG. 6