ATTO Technology FastStream SC 5700 - Manual (Page 59)

xii
PassThroughRediscover
SC 5500, 5700
Makes any previously-deleted pass through target devices
visible to the host.
PassThroughRediscover
Password
Specifies the password used for all sessions. Password is case
sensitive, 0 to 32 characters, and cannot contain spaces. An
empty password can be configured by pressing the enter key
when prompted for the new password and new password
confirmation.
Default: Password
set Password
Performance
Lists the performance data for the user-specified Fibre Channel
port. Data consists of the average rate (MB/sec) and number of
I/Os (IO/sec) measured over the previous sampling period
(approximately one second). Successful Read and Write
commands are considered I/Os. Factors that may affect
reported performance include port availability and saturation
and overall system utilization.
get Performance <fp>
Ping
Sends an ICMP echo request to the specified host.
ping [mp1] [xxx.xxx.xxx.xxx] <count <size>>
RAIDRebuildPriority
Regulates or displays the RAID rebuild priority. A RAID rebuild
priority set to high gives higher priority to RAID rebuilds and
lower priority to the processing of simultaneous I/O
transactions. A RAID rebuild priority set to low gives lower
priority to the rebuild and a higher priority to I/O transactions.
Set same, the RAID rebuild and processing of I/O transactions
is the same.
Default: same
set RAIDRebuildPriority <GroupName | all> [high | low |
same]
SaveConfiguration command required
get RAIDRebuildPriority <GroupName | all>
RAIDSpeedWriteLimit
Regulates the limit on the coalescing factor. A very low limit is
recommended for multiple initiators; a high limit is
recommended for multiple streams of sequential write I/O.
Default: 8
set RAIDSpeedWriteLimit [0-256]
get RAIDSpeedWriteLimit
ReadOnlyPassword
Specifies a password which allows only read and no writes. It is
case sensitive, 0 to 32 characters, and cannot contain spaces.
An empty password can be configured by not specifying one.
Default: Password
set ReadOnlyPassword
ReadOnlyUsername
Specifies the user name which allows only read and no writes.
It is case insensitive, 1 to 32 characters, and cannot contain
spaces.
Default: user
set ReadOnlyUsername [username]
get ReadOnlyUsername
Reserve
Reports the state of CLI reservation for the current CLI session.
If the command reports that Reservations are enabled, then
another CLI session has control of parameter modification on
the unit.
Reserve
ResetFCPortErrors
Changes all Fibre Channel error counts for the specified port to
zero. Refer to
FCPortErrors .
ResetFCPortErrors [fp | all]
RestoreConfiguration
Issued with the default option, forces the unit NVRAM settings
to their original defaults. The factory option forces the NVRAM
setting ot its original defaults and the unit’s original World Wide
Name. The saved option undoes any changes made to this
session since the last save.
RestoreConfiguration [Default | Factory | Saved]
RGAddStorage
Adds additional storage to an existing RAID group. MIRROR |
STRIPE | SPAN specifies the method used to expand the
storage. If the BlockDevID is omitted, the CLI command
RGMemberAdd must be used. Optional parameter commit
specifies that the RGCommit command is run automatically
and all user data is erased from each new member drive. If the
parameter is omitted, the CLI command
RGCommit must be
entered. You may enter several BlockDevIDs before the
commit parameter. Any time before
RGCommit is entered,
the command RGCancelAddStorage can to used to end the
process.
Note
MIRRORs can not be added to a RAID 4, 5 or
DVRAID group.
RGAddStorage [GroupName] [MIRROR | STRIPE |
SPAN] <BlockDevID>... <commit>>