Rapid-Air SERVO FEED WITH CUT-TO-LENGTH: 100, 200 & 300 SERIES - Manual (Page 16)

15
OPERATOR INPUT TERMINAL - PROGRAMMING PROCEDURE-STANDARD
SOFTWARE
The intent of this section is to familiarize the operator with the program flow and what
to expect with every keypress. Each screen on the display will be reviewed with
special comments to help clarify what is being asked on the screen. The program flow
is broken down into 5 sections with the main menu being the home postion.
The first screen to be displayed on the operator terminal will look like this
RAPID-AIR CORPORATION
4601 KISHWAUKEE STREET
ROCKFORD, IL 61109
815-397-2578
After a few seconds, the display will clear and the following display will appear:
MAIN SELECTION MENU
F1=JOB NUM F2=MANUAL
F3=AUTOMATIC CYCLE
F4=REVIEW PARAMETERS
SELECT F1=JOB #
The first step in programming the servo feed is to select a job number which will be
used to store the parameters the operator inputs or recall the parameters which have
been previously loaded into the servo controller program. When the operator selects
F1 on the keypad, the screen will change to:
JOB # SELECTION MENU
ENTER IN NEW JOB #=XX
PRESS F4 KEY AFTER
CORRECT # IS ENTERED
The operator must enter a 2 digit number before proceeding to any other function. If
the job number the operator has entered has been previously stored in memory, or
entering a new job, the folowing display will appear:
JOB NUMBER-01 LOADED
F1=PROGRAM PARAMETERS
F4=DON'T ALTER VALUES
THAT ARE PROGRAMMED!
If entering in a new job then select (F1) “program parameters” and follow the
directions.