Rapid-Air SERVO FEED WITH CUT-TO-LENGTH: 100, 200 & 300 SERIES User Manual
Page 9
8
INTERFACING SERVO FEED WITH A CUTTER
The Servo Drive unit is programmed to feed each time a signal is received from the
cutter switch. The servo will feed one progression and wait for the next signal before it
will feed again in automatic mode.
The command is in the form of a normally open contact from a proximity switch,
located on the cutter and is activated when the cutter is returned.
If the feed/cutter was purchased complete then the interfacing was done for you. If
not, then Rapid Air has provided wiring to a terminal block for interconnection
purposes. The interface schematic provides the wire numbers and how to connect the
cutter to the feed.
This completes the initial setup of the servo feed to the cutter or other device. The
servo is now ready to run as intended.
If more complete interfacing is needed, please refer to the section (interfacing ) in this
manual for an explanation of inputs and ouputs available.