Rapid-Air PALLET MASTER (PMD): PMD35 & PMD50. 115VAC, 1PH, 60HZ - Manual (Page 16)

Rapid Air Corporation
This should be done after the material has been started through the die so final
alignment has been achieved.
6. Adjust the height on the control arm.
7.
Adjust the spring pressure on type “B” or adjust counter balance weight on
type “A” control arm to just offset the effect of the material loop so the control
arm will go back to the starting (rest) position when the press is not demanding
material. After this has been completed, turn TRUN/STOP/JOG to “RUN”.
You are now ready to run.
CONTROL ADJUSTMENTS
The PMD has been fully tested and set for optimum performance at the factory.
Although this setting would normally be sufficient for most installations, there are
some cases where readjustments are needed for a smoother operation. Rapid Air
has provided 2 pots on the DC control board (RAMM) for fine tuning of the
acceleration and deceleration ramps. CAUTION!! Making these adjustments
should be done by qualified personnel using a plastic or insulated screw driver.
STANDARD EQUIPMENT
Spring Loaded ID keeper:
file:///C|/Web_develop/Pallet%20Master.htm (19 of 46) [12/10/2001 3:38:23 PM]