Progressive International Electronics PIcon II Console - Manual (Page 18)

PIcon II Operation
Rev 1.0 January 2014 13
Perform Shift Change — Before a shift change can be executed, totals from the shift must
be viewed or printed in their entirety, using the Special Select Functions <ENTER> or
<PRINT>. To execute a shift change, simply press the <CHANGE> key at the Function
prompt. When this has been accomplished, the PIcon II changes the Current Shift Total to
zero. The last shift total is then stored as Shift 1. At any time, there are four stored shift
reports. They are the Current Shift, Shift 1, Shift 2, and Shift 3, with Shift 3 being the oldest.
Please note that all shift reports are time/date stamped and contain a unique two-digit number
that increments by one each time a shift change takes place. In order to perform a shift
change, at least one hour must have elapsed since the last shift change.
After performing shift change, the display will return to the Select Function entry screen. If
another Select Function is desired, it may be entered, or Select Function may be exited by
pressing the <MANAGER> key.
Show Console Clock — The PIcon II’s built-in clock/calendar provides accurate time/date
stamping on reports and sales receipts. After being prompted for Function, press
<SELECT> to read the time and date.
Time and date will be displayed until another key is pressed. If another Select Function is
desired, it may be entered, or Select Function may be exited by pressing the <MANAGER>
key.
Turn Off Console — At the Function prompt, press <PUMP STOP>. At this point, all
LEDs are turned off and the word Off flashes on the display. Note that any fueling
transactions that have already begun when the PIcon II was turned off will be allowed to run
to completion.
To turn the PIcon II back on, enter the Operator, Manager, or Restricted PIN Code on the
numeric pad and press the <ENTER> key. The default Operator PIN Code is set at the
factory to 1111. The default Manager PIN Code is 2422. PIN Codes do not appear in the
display as they are entered on the numeric keypad. See the Manager Section of this manual
for instructions on changing the PIN Codes.