Maple Systems MAPware-100 - Manual (Page 22)

Go To Message
The Go To Message button is the shortcut for the Edit/Go To Message menu item. This
button gives the system programmer the ability to randomly jump to any message within the
system. Once the Go To Message button has been pressed, the following dialog box will
appear:
Enter the desired message number and either press Enter or click on the Go To Message
button. If you don’t desire to change messages, click on the Cancel button to return to the
previous message.
Configuration Editor
The Configuration Editor button is the shortcut for the Tools/Configuration Editor menu
item. This button is used to set up the system wide parameters: PLC addresses,
communication parameters, display viewing angle, passwords.
In all cases, the Default button will select the manufacturers recommended settings for a
given PLC model. Even though some settings for baud rate, parity, and data bits/stop bits
may not work properly with all PLCs, Maple Systems has allowed all settings to be user
adjustable in the event that the PLC manufacturers change the operation of the PLCs.
MAPware 100 User's Guide 21
1010-0089, REV00