Maple Systems MAPware-100 - Manual (Page 25)

If the Current Message Register is enabled, an address must be specified in the Address text
box. Pressing the Default button, resets the address to the default address which is two
greater than the address set in the Message group box in the Configuration Editor.
The value in the Current Message Register will either be in decimal or BCD format. It
depends on whether the BCD Format check box in the Message group box in the
Configuration Editor is checked.
Password Editor
Clicking on the Editor button within the Passwords box will display the following window:
The setup password is used to gain access to the OIT’s setup menu where local parameters
may be set as well as downloading from the PC.
Note: Make sure you remember the setup password! If you lose it, you will be unable to
download new configuration data or firmware to the OIT!
If the default setting (00000) is selected for the setup password, the operator can enter the
setup menu by entering five 0’s, or using a shortcut which is simply pressing the Enter key.
Function Key Editor
The Function Key Editor button is the shortcut for the Tools/Function Key Editor menu item.
The OIT has 12 or 16 programmable function keys, depending on the model. Each key has
the ability to be programmed as disabled, push on-push off, momentary, message display, or
latched. See the MAP Family Operation Manual for a description of each Function Key
mode. Clicking on the Function Keys button will display the function key editor screen:
24 OPERATION
1010-0089, REV00