Maple Systems MAPware-100 - Manual (Page 3)

4. Enter a:\setup (Substitute B for A if your 3.5-inch floppy drive is configured as a B
drive).
5. Choose the OK button.
6. The Setup program starts. Depending on your computer, this can take a few seconds.
7. Setup then prompts you for the location of the setup data files. Select the disk drive
which contains the setup disk (usually A:\).
8. Setup then prompts you for the destination directory for the MAPware 100 files. The
default is C:\MAPWARE.
9. If any other application programs are currently running under Windows, the
following message box will appear. It is strongly recommended that you shut down
any active programs (except video). If you do not, a setup error can occur.
2 GETTING STARTED
1010-0089, REV00