Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 227
Advertising
GP3000 Series Hardware Manual
9-18
(5)
Open the circuit board chassis, it’s turn left to right.
(6)
Disconnect the Backlight Unit cable from the connector on the inverter board, and then remove the cable
from the cable clamp.
(7)
As shown here, push the backlight unit’s attachment clip to the right to release the backlight unit.
• A hot circuit board chassis can burn you. Be sure the chassis has cooled completely
prior to replacing the backlights.
Circuit board chassis
Connector
Inverter
Backlight Unit
for bottom
Cable Clamp
Backlight Unit
Hook
Advertising
This manual is related to the following products: