Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 159)

GP3000 Series Hardware Manual
5-6
5.2 Wiring to the DIO Connector
‹ Items Required to Wire Connectors
• Screwdriver
Recommended type: 1891348-1 <Tyco Electronics AMP.>
If another manufacturer is used, be sure the part has the following dimensions:
point depth: 1.5mm [0.06in.]
point width: 2.4mm [0.09in.]
Point shape should be DIN5264A, and meet Security Standard DN EN60900.
Also, the screwdriver’s tip should be flat as indicated in order to access the narrow hole of the connector:
The connectors are a spring clamp type.
Use the following procedure to connect the wires to the connectors.
„ DIO Cable Specifications
„ Connecting the DIO Cable
(1) Insert a slot screwdriver, at an angle, into the tool insertion hole (square-shaped hole) of the connector.
(2) When inserting the flathead screw driver, be sure that it is perpendicular to the center division wall.
Be sure to remove the DIO Connector from the GP unit prior to starting wiring. Failure to do
so may cause an electric shock.
DIO Cable Diameter
AWG24 to 18
UL1015 or UL1007
Conductor Type Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are not twisted correctly, the end
wires may either short against each other, or against an electrode.
Conductor Length
• Insert the screwdriver approximately 4 mm [0.16 in.]. Inserting forcefully may break the inside
of the connector and cause a contact defect.
Also, do not turn the screwdriver while the tip is inside of the tool insertion hole (square-shaped
hole).
Screwdriver Tip
Shape
7 mm
[0.28in]