Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 189)

GP3000 Series Hardware Manual
8-18
8.3 CF Card Insertion/Removal
This section describes how to insert and remove a CF Card.
When using the GP Unit and a CF Card, observe the following precautions:
Prior to inserting or removing a CF Card, be sure to turn the AGP unit’s CF Card ACCESS
switch OFF and to confirm that the ACCESS lamp is not lit. If you do not, CF Card internal
data may be damaged or lost.
While a CF Card is being accessed (Status LED: Green ON), NEVER turn OFF or reset the
GP, or insert or remove the CF Card. If you do not, CF Card internal data may be damaged
or lost.
Prior to inserting a CF Card, familiarize yourself with the CF Card’s front and rear face
orientation, as well as the CF Card connector’s position. If the CF Card is not correctly
positioned when it is inserted into the Multi Unit, the CF Card’s internal data and the GP
unit may be damaged or broken.
Be sure to use only CF Cards manufactured by Pro-face. The CF Card’s internal data may
be damaged when using another manufacturer’s CF Card.
Once GP data is lost, it cannot be recovered. Since accidental data loss can occur at any
time, be sure to back up all GP screen and CF Card data regularly.
Be sure to follow the instructions given below to prevent the CF Card’s internal data from
being destroyed or a CF Card malfunction from occurring:
• DO NOT bend the CF Card.
• DO NOT drop or strike the CF Card against another object.
• Keep the CF Card dry.
• DO NOT touch the CF Card connectors.
• DO NOT disassemble or modify the CF Card.