Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 213)

GP3000 Series Hardware Manual
9-4
9.3 Replacing the Installation Gasket
The installation gasket provides protection against dust and moisture.
„Installation Gasket Attachment Procedure
(1) Place the GP on a flat, level surface facing the display face downwards.
(2) Remove the gasket from the GP.
(3) Attach the new gasket to the GP. Be sure to insert the gasket into the GP’s groove so that the gasket’s
groove sides are vertical.
(4) Check that the gasket is attached correctly to the GP.
• A gasket which has been used for a long period of time may have scratches or dirt
on it, and could have lost much of its water resistance. Be sure to change the gasket
at least once a year, or when scratches or dirt become visible.
• The GP unit installation gasket’s model number is as follows.
GP-3200 Series ST400-WP01
GP-3300 Series CA3-WPG6-01
GP-3400 Series CA5-WPG8-01
AGP-35*0T CA5-WPG10-01
AGP-3500L/3500S CA3-WPG12-01
GP-3600 Series CA3-WPG12-01
GP-3700 Series CA3-WPG15-01
GP Rear Face
Gasket Seam
Gasket
Installation
Groove