Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 59)

GP3000 Series Hardware Manual
3-14
3.5 GP-3600 Series
The following images of an AGP- 3650T (AC model) unit.
A: Status LED
This LED indicates the GP’s status, e.g. power
input, firmware RUN status or backlight condition.
Also, indicates the status of logic program
execution.
B: DIO Interface (DIO board type only)
FLEX NETWORK Interface (FLEX
NETWORK board type only)
CANopen Interface (CANopen board type
only)
The interface to which the unit with
communication capabilities is connected.
C: FLEX NETWORK Communication Status
LED
The LED indicates the status of FLEX NETWORK
communication. The LED turns on to indicate the
current status.
D, E, F: CANopen Status LED
This LED indicates the communication status of
the CANopen.
Color Indicator
Operation
Mode
(Drawing)
Logic execu-
tion mode
(when logic is
enabled)
Green
ON
OFFLINE -
In
operation
RUN
Flashing
In
operation
STOP
Red
ON When power is turned on.
Flashing
In
operation
Major Error
Orange
ON
Backlight burnout or
GP malfunction *1
*1 Please see "Chapter 9 Replacing the Backlight
(page9-6)" for the details.
Flashing During software startup
Status LED Indicates
RUN (Green)
Turns on when
Communication is enabled.
ERR (Red)
Turns on when failure
occurs in connected I/O
Unit.
Status LED Indicates
D
PWR
(Green) ON: When applying current,
OFF: When light is off
E
RUN
(Green) Turns on when
Communication is enabled.
F ERR (Red)
Turns on when failure
occurs in connected slaves
(ex.) Hybrid Terminal Block.
G
H
B
C
Front
A
Left side
DIO board type
FLEX NETWORK
board type
E
F
D
CANopen board type