Proface LT4300M - 5.7 Modular HMI + Control" - Manual (Page 24)

24
English
The figure shows the minimum clearance for the rear module:
Installing the Rear Module on a DIN Rail
The following procedure describes how to install the rear module on a DIN rail:
 Fasten the DIN rail to a panel surface using screws.
 Affix the display module/rear module separation cable to the rear module.
 Position the top groove of the rear module on the top edge of the DIN rail and press the
assembly against the DIN rail until you hear the DIN rail clip click into place.
 Install the display module onto the cabinet.
 Affix the display module/rear module separation cable to the display.
The figure shows how to install the rear module on a DIN rail: